It is important to use extra care when using a rough terrain scissor lift. Drivers must be completely aware of the surrounding environment. Long booms on the equipment act as levers from the center of the drive unit. For example, a 6 inch bump can cause a 3 foot bounce when the driver is at the driver controls. Consider all other traffic nearby, because they might not be aware that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface which has no mud or water. These areas cover deep potholes which can be possibly cause the occupants to fall if the tires fell into the holes. If provided, utilize all of the outriggers, extended to their full extension position. Be certain to only use approved wooden chalk blocks.
Many lifts operate from a metal platform on the end of the boom. The long booms act as levers from the drive unit's center. A 6-inch bump can cause a 3-foot bounce while you are at the driver controls. Be aware of all other traffic. They might not know that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas could conceal deep potholes wherein the lift tires can fall, tipping the occupants. Extend all outriggers, if provided, fully. Place only approved wooden chalk blocks under the outrigger pads to prevent the unit from moving.
Overhead power lines are a serious danger for lift operators regardless of what lift is being utilized. For example, if the driver of the platform is not being aware, or if the platform is being controlled by ground personnel which is not able to correctly access nearness to wiring and hence, either the worker or the platform itself could be easily brought into contact with electrical wires. The employee might be electrocuted unfortunately unless properly insulated.